SNMP Overview Using SNMP
page 3-24 OmniSwitch AOS Release 6 Switch Management Guide July 2010
57 alaStackMgrOutOfTokensTrap alaStack-
MgrSlotNI-
Number
chassis The element identified by
alaStackMgrSlotNINumber will
enter the pass through mode
because there are no tokens
available to be assigned to this
element.
alaStackMgrSlotNINumber—Numbers allocated for the stack NIs as follows:
- 0: invalid slot number
- 1..8: valid and assigned slot numbers corresponding to values from the entPhysicalTable
- 1001..1008: switches operating in pass through mode
- 255: unassigned slot number.
Note: This trap is not supported on OmniSwitch 9000 switches.
58 alaStackMgrOutOfPassThruSlotsTrap N/A chassis There are no pass through slots
available to be assigned to an ele-
ment that is supposed to enter the
pass through mode.
Note: This trap is not supported on OmniSwitch 9000 switches in the current release.
59 gmHwVlanRuleTableOverloadAlert gmOverloadRu-
leTable
gmOverloadRu-
leType
gmOverloadRu-
leVlanId
gmOverloadRu-
leMacAd-
dress
gmOverloadRu-
leIpAddress
gmOverloadRu-
leProtocol
gmOverloadRu-
leIpxNetwork
vlan An overload trap occurs when-
ever a new entry to the hardware
VLAN rule table gets dropped
due to the overload of the table.
gmOverloadRuleTable—Overloaded hardware VLAN rule table.
gmOverloadRuleType—VLAN rule types that are not configured due to the overload of the hardware VLAN
rule table.
gmOverloadRuleVlanId—The overloaded VLAN ID.
gmOverloadRuleMacAddress—The overloaded MAC address.
gmOverloadRuleIpAddress—The overloaded IP address.
gmOverloadRuleProtocol—The overloaded protocol type.
gmOverloadRuleIpxNetwork—The overloaded IPX network address.
60 lnkaggAggUp traplnkaggId
traplnkaggPor-
tIfIndex
linkaggre-
gation
Indicates the link aggregate is
active. This trap is sent when any
one port of the link aggregate
group goes into the attached
state.
traplnkaggId—Index value of the Link Aggregate group.
traplnkaggIfIndex—Port of the Link Aggregate group.
No. Trap Name Objects Family Description
To Next Page
Loading...
