Alcatel-Lucent OmniTouch Contact Center - Supervisor Call

___change-begin___
___change-end___
1. Press the "WrapUp" softkey.
The following screen is displayed:
___change-begin___
___change-end___
The "WrapUp" softkey is flashing.
2. To exit from the "WrapUp" state and come back to the Pause state, press the
softkey or wait for the end of the "WrapUp" timer.
3.6 Supervisor Call
Role: This function is used to call the supervisor.
Prerequisites: This function is accessible if your set is in "Idle", "WrapUp" or "Pause between
calls" states.
Procedure:
- The set is in Idle state.
___change-begin___
___change-end___
- The set is in WrapUp state.
___change-begin___
* 
     !" #$         
3-5