If the sets must initialize dynamically, the auto provisioning must be activated: see Security - Auto
provisioning
4.6.1.4.1 Requested IP parameters
The following information must be provided for static initialization:
• IP address (set's address)
• Subnetwork mask
• Router address
• TFTP1 server address (parameter not used)
• TFTP2 server address (parameter not used)
• Use VLAN: this box must be checked to enter a VLAN number
• VLAN number if necessary
• Strict VLAN if necessary
• TFTP port
With dynamic initialization, IP parameters are automatically sent by a DHCP server to the phone.
The following information must be provided for initial startup:
1. From the Registration window, enter:
a. The set directory number
b. The set Password
If the set has already been initialized in the same configuration, there is no need to enter the directory
number and password again.
4.6.1.4.2 Deny of download
If the downloaded version is different from the version installed on the set and if the downloaded binary
is incompatible with the hardware/software, the terminal denies it and signals the problem to the Call
Server.
The terminal requests binary files at each reset until a compatible binary is found.
Deny of download also applies to SIP binary.
4.6.1.5 Binary file download
To operate correctly, 80x8 sets require binary files, automatically downloaded at set initialization. These
files must comply with the PBX version and configuration. After system upgrade and each time a set
initializes, version numbers of binary files are verified to determine whether an update of these files is
necessary.
When a file is downloaded to the set, it overwrites any previously existing file.
Each time the IP phone is initialized, its binary version is checked to see whether more recent binaries
need downloading.
When a set has initialized at least once with the PBX, on subsequent startup, it does not request a
binary header and switches to fast initialization.
The version of binary files for Premium DeskPhone sets. starts with 4.50.YY
Chapter
4
Installation and Cabling
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 100/207
To Next Page
Loading...
Need help?
General
