Enter the URL: https://<OXO Connect_IP_address>:10443/dmcfg and select HTTPS as
protocol
10.Press the Save softkey
Important:
If the OXO Connect is installed and configured in a VLAN topology, the VLAN must be manually enabled in
the advanced settings of the set. The corresponding OXO Connect VLAN Value must be entered manually
in set configuration.
4.4.1.1.6 Upgrading set binaries
If requested:
1. In OMC, select Import/Export > File Management For third Party Devices
2. Import the binary files and firmware configuration files in the directory named: Binary
3. Reboot the set manually
When the set connects to the OXO Connect, it upgrades its software, provided the binaries
imported in the system and the binaries present in the set are of a different version.
Note:
Set binaries can be imported or deleted, but not exported
4.4.1.1.7 Replacing the set by another 8001/8001G Deskphone set
In case of a replacement by another 8001/8001G Deskphone set, modify the MAC address of the set in
OMC.
There is no backup of terminal data, which means that the local call log and saved contacts are lost.
To replace a set initially installed as Open SIP phone by a same set and have it recognized properly by
the system:
1. Disconnect the phone from the network
2. In OMC, delete the registration Open SIP Phone
3. Reconnect the 8001/8001G Deskphone
It initializes normally and the OXO Connect license-bypass mechanism makes it appear as a SIP
8001/8001G Deskphone.
It is preferable to disconnect 8001/8001G Deskphone set from the network during this operation. Once
reconnected, the set initializes normally and the OXO Connect license-bypass mechanism makes it
appear as a SIP phone 8001/8001G Deskphone.
4.4.1.1.8 8001/8001G Deskphone password management
After a 8001/8001G Deskphone SIP Phone starts with the OXO Connect, the user password for the set
web interface is changed from the default values: root / root to admin / admin.
To configure the set, if no new administrator password has been manually entered:
• On the 8001/8001G Deskphone set : when the password is requested, do not enter anything and
select OK (or try as 000000 password)
• From the web Admin interface, enter: admin / admin
If there is a specified password, different from the default password, for a 8001/8001G Deskphone SIP
phone configured in the OXO Connect, after the set is connected to the system, the login changes to
admin with the password specified in OMC System Misc/SIP Phone Admin password/SIP phone for
the phone.
If a manual 8001/8001G Deskphone SIP phone reset to factory settings is requested (for instance if the
administrator password is lost), on the set:
1. Go Menu > Functions Settings > Dial to find:
Chapter
4
Installation and Cabling
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 75/207
To Next Page
Loading...
Need help?
General
