Algo 8201 - Basic Settings - Door Control; Door Unlock and Relay Configuration

Document 90-00073D Algo Communication Products Ltd (604) 454-3792
2016-09-29 4500 Beedie St Burnaby BC Canada V5J 5L2 support@algosolutions.com
Page 20 www.algosolutions.com
Basic Settings Tab – Door Control
The 8201 can be used with the optional 8061 SIP Relay
Module for additional door security as it is located inside the building.
This section allows you to configure the 8061 IP Relay Controller
settings (if used), as well as the settings for the on-board relay. For
more information about the 8061, see “8061 IP Relay Controller” on
page 35.
Network Door Controller Address
IP address of the optional 8061 IP Relay Controller.