Document 90-00073D Algo Communication Products Ltd (604) 454-3792
2016-09-29 4500 Beedie St Burnaby BC Canada V5J 5L2 support@algosolutions.com
Page 29 www.algosolutions.com
MD5 Checksum
In addition to the .conf file, an .md5 checksum file must also be
uploaded to the Provisioning server. This checksum file is used to
verify that the .conf file is transferred correctly without error.
A tool such as can be found at the website address below may be
used to generate this file: http://www.fourmilab.ch/md5
The application doesn’t need an installation. To use the tool, simply
unzip and run the application (md5) from a command prompt. The
proper .md5 file will be generated in the same directory.
If using the above tool, be sure to use the “-l” parameter to generate
lower case letters.
Generating a generic configuration file
1. Connect 8201 to the network
2. Access the 8201 Web Interface Control Panel
3. Configure the 8201 with desired options
4. Click on the System tab and then Maintenance.
5. Click “Backup” to download the current configuration file
6. Save the file settings.txt
7. Rename file settings.txt to algop8201.conf
8. File algop8201.conf can now be uploaded onto the Provisioning
server
If using a generic configuration file, extensions and credentials have
to be entered manually once the 8201 SIP PoE Intercom has
automatically downloaded the configuration file.
To Next Page
Loading...
