Alienware Area-51 R2 - Removing the Front-Bezel Heat-Sensor; Prerequisites; Procedure

Removing the Front-bezel
Heat-sensor
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
Before Working Inside Your Computer.
After working inside your computer, follow the instructions
in After Working Inside Your Computer. For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Prerequisites
1 Remove the stability foot.
2 Remove both the left and right side-panels. See “Removing the Side
Panels”.
3 Remove the PCI fan. See “Removing the PCI fan”.
Procedure
NOTE: After removing the PCI fan, locate the sensor on the fan shroud.
1 Lay the computer on the left side.
2 Press the release tab on the securing clip.
3 Pry out the chassis heat-sensor cable from the securing clip.
86