Alienware Aurora R15 - Installing the Processor Liquid-Cooling Assembly

7. Release the spring latch and lift the processor-cooling assembly, along with the cables, off the system board.
Installing the processor liquid-cooling assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
CAUTION: Incorrect alignment of the processor liquid-cooling assembly can damage the system board and processor.
CAUTION: If either the processor or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure
that thermal conductivity is achieved.
About this task
The following images indicate the location of the processor liquid-cooling assembly and provide a visual representation of the
installation procedure.
58