19
Basic Operations
Memory Mode
This mode allows recalling and operating the preprogrammed frequency or setting. This unit pro-
vides up to 200 memory channels (80 exclusive channels each for VHF and UHF, from 00 to 79CH
and 40 common channels for VHF and UHF, from 100 to 139), 1 CALL channel each for V and U
(C), 1 program-scan edge memory channel each for V and U (PL) (PH) and 1 VFO automatic
Memory mode
Memory channel
In case the SUB side is in the memory mode
program setting channel (AL) (AH).
Recalling a memory channel
1. Select the memory mode by pressing V/M key.
[00] appears on the display to indicate that the
unit is in the memory mode.
Repeat to switch between memory and VFO.
2. Select a memory channel.
Rotating the main dial (or by pressing the UP/
DOWN Mic keys) will increase or decrease a
memory channel number by 1 channel step. For
recalling a memory on the SUB band, first
switch the MAIN band by pressing the BAND
key. When the SUB side is in the memory mode
or CALL mode, [ ] appears on the display.
When recalling any memory number between
100 and 139, the display on the SUB side will
disappear.
IMPORTANT: If memory channels have not been programmed, the unit will not be
switched to the memory mode by pressing V/M key. Please read memory
channel programming on the next page.
To Next Page
Loading...
