Alinco DR-B185HT - Default Dcs Value; Auto-Dialer

29
7
PARAMETER SETTING MODE
2.
Press dial to display SET, then rotate dial or press the [UP]/[DOWN]
keys on the microphone to change the setting.
Available parameters are OFF and 67.0Hz to 250.3Hz (See the
table below). When a tone frequency is selected, it resumes as a
default parameter every time the unit is turned on, regardless of
previous setting. By setting OFF, the tone selected by
TS/DCS
key
remains unchanged.
CTCSS tone chart
67.0 69.3 71.9 74.4 77.0 79.7 82.5 85.4 88.5 91.5
94.8 97.4 100.0 103.5 107.2 110.9 114.8 118.8 123.0 127.3
131.8 136.5 141.3 146.2 151.4 156.7 162.2 167.9 173.8 179.9
186.2 192.8 203.5 210.7 218.1 225.7 233.6 241.8 250.3
3.
Press the dial.
The unit will go back to menu mode.

DEFAULT DCS VALUE
Set the DCS value which is displayed by operating the
TS/DCS
key after
turning on the power.
1.
Rotate the dial or press the [UP]/[DOWN] keys on the microphone
to display the menu number "19".
The current setting will appear on the
display.
The default setting is "OFF".
2.
Press dial to display SET, then rotate dial or press the [UP]/[DOWN]
keys on the microphone to change the setting.
Available parameters are OFF and 023 to 754 (See the table
below). When a DCS tone is selected, it resumes as a default
parameter every time the unit is turned on, regardless of previous
setting. By setting OFF, the DCS selected by
TS/DCS
key remains
unchanged.
023 025 026 031 032 036 043 047 051 053
054 065 071 072 073 074 114 115 116 122
125 131 132 134 143 145 152 155 156 162
165 172 174 205 212 223 225 226 243 244
245 246 251 252 255 261 263 265 266 271
274 306 311 315 325 331 332 343 346 351
356 364 365 371 411 412 413 423 431 432
445 446 452 454 455 462 464 465 466 503
506 516 523 526 532 546 565 606 612 624
627 631 632 654 662 664 703 712 723 731
732 734 743 754
3.
Press the dial.
The unit will go back to menu mode.

AUTO-DIALER
This will automatically transmit pre-programmed DTMF tones.
To program tones in the Auto-dialer memory:
1.
Rotate the dial or press the [UP]/
[DOWN] keys on the microphone to
display the menu number "20".