Rockwell Automation Publication 1734-UM018D-EN-E - September 2017 37
Configure the Adapter for Direct Connection in RSLogix 5000 or Logix Designer Software Chapter 4
6. Click Change...
The Module Definition dialog opens.
7. Enter or select values for Revision, Electronic Keying, Rack Connection,
and Time Sync Connection, noting that we used the following values:
8. Click OK to accept the configuration.
The module appears indented under the I/O Configuration folder.
Series A
Revision 5.1
Electronic Keying Compatible Module
Rack Connection None
Time Sync Connection None
To Next Page
Loading...
