42 Rockwell Automation Publication 1734-UM018D-EN-E - September 2017
Chapter 4 Configure the Adapter for Direct Connection in RSLogix 5000 or Logix Designer Software
2. Select the appropriate filter for Module Type Category (for the example we
selected Digital) and Module Type Vendor (for the example we selected
Allen-Bradley).
Note: to select only one category you will need to unselect those already
selected.
3. From the modules listed select the 1734-OW2 digital relay output module
and click Create.
The New Module dialog opens.
4. Enter values for Name and Slot, noting that we used the following values.
Name POINT_Relay_Output
Slot 1
To Next Page
Loading...
