68 Rockwell Automation Publication 1734-UM018D-EN-E - September 2017
Chapter 5 Configure the Adapter for Direct Connection, Rack Optimization, and Enhanced Rack Optimization in RSLogix 5000 or Logix Designer Software
7. In the New Module screen select the Connection tab and verify that the
Requested Packet Interval (RPI) used for the rack-optimization
connection to the I/O modules is appropriate for your system (20.0 ms for
this example). If not, change it to the correct value.
8. Click OK to accept the configuration.
The digital output module appears indented under the local
1734-AENT/B adapter in the I/O Configuration folder.
To Next Page
Loading...
