PanelView 550 Terminals 5
40061-325-01(D)
European Union Directive Compliance
If a PanelView 550 Operator Terminal is installed within the European Union or
EFTA regions and has a CE mark, the following regulations apply.
EMC and Low Voltage Directives
This apparatus is tested to meet Council Directive 89/336/EEC Electromagnetic
Compatibility (EMC) and amending directives 91/263/EEC, 92/31/EEC, 93/68/
EEC; 72/23/EEC Low Voltage Directive, and amending directive 93/68/EEC
using the following standards, in whole or in part:
• EN 50081-2:1993 EMC - Generic Emission Standard, Part 2 - Industrial
Environment
• EN 50082-2:1995 EMC - Generic Immunity Standard, Part 2 - Industrial
Environment
• EN 61131-2:1995 EMC - Programmable Controllers - Equipment
Requirements and Tests
• Low Voltage Directive - Safety Sections of EN 61131-2
The product described is intended for use in an industrial environment.
Intended Use of Product
According to these Standards, the factor which determines, for EMC purposes,
whether an apparatus is deemed to be “Industrial” or “Residential, commercial
and light industrial”, is given in Clause 1 of EN50081-2 as follows:
Apparatus covered by this standard is not intended for connection to a public
mains network but is intended to be connected to a power network supplied
from a high- or medium-voltage transformer dedicated for the supply of an
installation feeding a manufacturing or similar plant.
The PanelView 550 terminals are intended for use solely in an industrial
environment as defined above. When installed in Europe, any other application
is in contravention of European Union Directives, and a breach of these laws.
To Next Page
Loading...
Need help?
General
