116 Rockwell Automation Publication 2711P-UM006A-EN-P - November 2010
Chapter 6 Install and Replace Components
Clean the Display
Use a protection antiglare overlay for easier cleaning of the display screen.
Follow these steps to clean the display screen.
1. Disconnect power from the terminal.
2. Use a clean sponge or soft cloth with mild soap or detergent to clean the
display.
3. Dry the display with a chamois or moist cellulose sponge to avoid water
spots.
Remove fresh paint splashes and grease before drying by rubbing lightly with
isopropyl alcohol (70% concentration). Then wash the display using mild soap or
detergent. Rinse with clean water.
ATTENTION: Use of abrasive cleaners or solvents may damage the
display. Do not scrub or use brushes.
To Next Page
Loading...
Need help?
General
