Rockwell Automation Publication 2711P-UM006A-EN-P - November 2010 91
Windows CE Operating System Chapter 5
Screen Saver
The screen saver extends the lifetime of the display by dimming the backlight
when the terminal is idle. The screen saver will activate and display a moving
bitmap at a reduced brightness level after a continuous idle time. When the screen
saver is deactivated, the display brightness returns to its normal brightness level.
The Screen Saver tab on the Display Properties applet lets you perform these
operations:
• Enable the screen saver using a specified idle timeout. The default idle time
is 10 minutes.
When the screen saver is activated, the dimmer controls the backlight
intensity level. You set the brightness level of the dimmer in the range
0…100%. The default dimmer intensity is 10%. At 0%, the backlight is off
and the display is dark.
• Browse the system for a bitmap to be displayed by the screen saver at a
nonzero brightness level. The default screen saver is SSFloat.bmp. Use the
Add or Remove buttons to change the screen saver bitmap. The system
recognizes bitmaps stored in the \Windows folder.
• Disable the screen saver by clearing the Start screen saver checkbox.
Cursor
The Cursor tab of the Display Properties applet lets you enable or disable the
visible cursor that you see on the display. The cursor is visible by default.
.
To Next Page
Loading...
Need help?
General
