114 Rockwell Automation Publication 1783-UM010C-EN-P - June 2019
Chapter 9 Updating the Device
13. At this point, copy over and install SFR (which takes 2 hours).
This can be done from FTP, TFTP, or HTTP, but not from an SD card.
The system indicates that it is verifying, downloading, and extracting,
which takes a few minutes on a direct link.
Ty p e system install noconfirm ftp://
FTP_IP_ADDRESS/asasfr-sys-6.44.0-102.pkg
About 20 to 30 minutes into the two-hour process, the system indicates,
“Finished extracting, will issue a reboot”.
The system upgrades and populates the new system image for about 20
minutes, and then there is another restart of the SFR.
Another restart of the SFR occurs several minutes later. If you press a key,
you receive a message that the system was terminated, and then the ASA
command prompt returns.
The system indicates “status up” when complete, usually about two hours.
14. Type show module sfr detail to return data, such as IP
addresses. Important data includes ‘Data Plane Status: UP’ and ‘Console
session: Ready’.
15. SFR Command Show Module SFR Detail
16. Type session SFR console to return to the SFR.
You are prompted for the username and password.
17. Log in with username=admin, password=Admin123.
The EULA is displayed.
IMPORTANT Do not power off your system. This restart is for the SFR side only.
IMPORTANT Do not restart your system. This restart is for the SFR side only.
IMPORTANT Do not power off the system during those two hours.
To Next Page
Loading...