Rockwell Automation Publication 1783-UM010C-EN-P - June 2019 113
Updating the Device Chapter 9
• Ready/Recover indicates that the device is ready for a console session
and to be configured
The Ready/Recover status can take up to five minutes to display.
8. Type Session SFR console.
9. Log in with username=admin, password=Admin123. This installation
is new, and it requires the default password. This password is changed in
later steps.
10. Type setup to configure the SFR.
11. Type the IP address, Network mask, and Gateway details you recorded in
step 1.
12. When prompted to apply the changes, Type y.
Note: At this point, if you use a ping to validate your network
connectivity, you must press CTRL-C to interrupt; otherwise, it
endlessly pings.
To Next Page
Loading...