84 Rockwell Automation Publication 1783-UM010C-EN-P - June 2019
Chapter 6 Hardware Bypass
[no] hardware-bypass gigabitethernet {1/1-1/2|1/3-1/4}
[sticky]
This CLI command is used to enable or disable the bypass mode during power
down and power up.
Hardware Bypass Behavior During Power Down
To enable hardware bypass mode when power is lost to the appliance the
following CLI is used.
stratix5950# conf t
stratix5950(config) #hardware-bypass gigabitethernet 1/1-1/2
To disable hardware bypass mode when power is lost and power up to the
appliance the following CLI is used.
stratix5950# conf t
stratix5950(config) #no hardware-bypass gigabitethernet 1/1-
1/2
"Hardware Bypass Behavior During Power Up
When hardware bypass is enabled with the power up option, traffic continues
to flow on the bypass port pair even after the system boots up. To enable bypass
on power up, we must also enable for power fail because the hardware supports
power up along with power fail option. The option of power up only is not
supported in the hardware.
To enable hardware bypass mode with the power down and power up option,
the following CLI is used.
stratix5950 # conf t
stratix5950(config)#hardware-bypass gigabitethernet 1/1-1/2
sticky
This command would disable both power up and power down for ports 1 and
2. The following CLI is used:
stratix5950(config)#no hardware-bypass gigabitethernet 1/1-
1/2
[no] hardware-bypass manual gigabitethernet {1/1-1/2|1/3-1/
4}
This CLI command is used to enable/disable the bypass feature when the
appliance is powered and able to run. This CLI command does not depend on
the power fail or power up option that is discussed in earlier sections.
To Next Page
Loading...