Rockwell Automation Publication 1783-UM010C-EN-P - June 2019 85
Hardware Bypass Chapter 6
To enable hardware bypass mode with the manual option, the following CLI
is used.
stratix5950# hardware-bypass manual gigabitethernet 1/1-1/2
When hardware bypass is disabled with the manual option, the traffic stops on
the bypass port pair immediately and flow through physical interfaces.
To disable hardware bypass mode with the manual option, the following CLI
is used.
stratix5950# no hardware-bypass manual gigabitethernet 1/1-
1/2
"[no] hardware-bypass boot-delay module sfr
This CLI command is used to enable/disable bypass operation delay based on
SFR boot status. If it is turned on, the bypass only turns off if SFR module is
full up. If it is not turned on, the bypass is turned off once the ASA module is
ready. If bypass is not enabled, this command does not have any impact.
For a listing of Cisco documentation, see Additional Resources on page 8
.
To Next Page
Loading...