58 M413438
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
73. LOADING DOOR ASSEMBLY
Refer to Figure 31.
a. Open loading door.
b. While supporting door, remove upper hinge
shoulder bolt holding door to hinge bracket.
c. Remove door from hinge bracket.
NOTE: Nylon washer must be in place on lower pin
when reinstalling loading door.
Figure 31
PHILLIPS
HEAD
SCREW
LOADING
DOOR
DOOR
HANDLE
TU030-SV TU031-SV
LOADING
DOOR
BAR
ATTACHING
SCREW
BAR
ATTACHING
SCREW
DOOR
BAR
ALTERNATE STYLE
To Next Page
Loading...
