M413438 61
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
77. DOOR SWITCH
Refer to Figure 35.
a. Remove control panel.
b. Disconnect wires from door switch.
c. Remove two screws holding door switch to
bracket (older models).
NOTE: Refer to wiring diagram when rewiring
door switch.
Loading door switch MUST be reinstalled
after service is completed.
W272
WARNING
Figure 35
T034SE1B
DOOR
SWITCH
SCREWS
To Next Page
Loading...
