Allied Telesis AT-9000/28SP User Manual

AT-9000 Switch Command Line User’s Guide
1001
NO SNMP-SERVER
Syntax
no snmp-server
Parameters
None
Mode
Global Configuration mode
Description
Use this command to disable SNMPv1, SNMPv2c, and SNMPv3 on the
switch. The switch does not permit remote management from SNMP
applications when SNMP is disabled. It also does not send SNMP trap or
inform messages.
Confirmation Command
“SHOW SNMP-SERVER” on page 1008.
Example
This example disables SNMPv1, SNMPv2c, or SNMPv3 on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)