To Next Page

To Previous Page

AT-9000 Switch Command Line User’s Guide

771

Setting the GVRP Timers

The switch has a Join Timer, a Leave Timer, and a Leave All Timer. You

should not change the timers unless you understand their functions. (Refer

to the IEEE 802.1p standard for the definitions.) The timers have to be set

the same on all GARP-active network devices, and the Join Timer and

Leave Timer have to be set according to the following equation:

Join Timer <= (2 x (Leave Timer))

The commands for setting the timers are in the Global Configuration

mode. They are:

gvrp timer join

value

gvrp timer leave

value

gvrp timer leaveall

value

The timers are set in one hundredths of a second. This example sets the

Join Timer to 0.2 seconds, the Leave Timer to 0.8 seconds and the Leave

All timer to 10 seconds:

awplus> enable

awplus# configure terminal

awplus(config)# gvrp timer join 20

awplus(config)# gvrp timer leave 80

awplus(config)# gvrp timer leaveall 1000

For reference information, refer to “GVRP TIMER JOIN” on page 786,

“GVRP TIMER LEAVE” on page 787 and “GVRP TIMER LEAVEALL” on

page 788.

Allied Telesis AT-9000/28SP User Manual

Other manuals for Allied Telesis AT-9000/28SP