To Next Page

To Previous Page

AT-9000 Switch Command Line User’s Guide

133

BANNER EXEC

Syntax

banner exec

Parameters

None

Mode

Global Configuration mode

Description

Use this command to create a banner for the User Exec and Privilege

Exec modes. The message is displayed above the command line prompt

when you log on or clear the screen with the CLEAR SCREEN command,

in local, Telnet, and SSH management sessions.

After you enter the command, the “Type CTRL/D to finish” prompt is

displayed. Enter a banner message of up to 256 characters. Spaces and

special characters are allowed. When you are finished, press CTRL D.

To remove the banner, use the NO version of this command, NO BANNER

EXEC.

Note

Web browser management sessions do not display this banner.

Confirmation Command

“SHOW RUNNING-CONFIG” on page 158

Examples

This example creates the banner “Production Switch 1P” for the User Exec

and Privileged Exec modes:

awplus> enable

awplus# configure terminal

awplus(config)# banner exec

Type CNTL/D to finish

Production Switch 1P

Allied Telesis AT-9000/28SP User Manual

Other manuals for Allied Telesis AT-9000/28SP