Allied Telesis AT-9000/28SP - Lldp Med-Tlv-Select

Chapter 68: LLDP and LLDP-MED Commands
1092
LLDP MED-TLV-SELECT
Syntax
lldp med-tlv-select capabilities|network-
policy|location|power-management-ext|inventory-
management|all
Parameters
capabilities
Specifies the capabilities TLV.
network-policy
Specifies the network policy TLV.
location
Specifies the location identification TLV.
power-management-ext
Specifies the extended power-via-MDI TLV.
inventory-management
Specifies the inventory management TLV.
all
Configures a port to send all LLDP-MED TLVs.
Mode
Port Interface mode
Description
Use this command to specify the LLDP-MED TLVs the ports are to
transmit to their neighbors. The default setting is for the ports to send all
the LLDP-MED TLVs, except for the inventory TLV. You can specify only
one TLV per command. To remove LLDP-MED TLVs from the ports, refer
to “NO LLDP MED-TLV-SELECT” on page 1113.
Confirmation Command
“SHOW LLDP INTERFACE” on page 1123