Allied Telesis AT-9000/28SP - Auth Timeout Supp-Timeout

Chapter 61: 802.1x Port-based Network Access Control Commands
932
AUTH TIMEOUT SUPP-TIMEOUT
Syntax
auth timeout supp-timeout value
Parameters
supp-timeout
Sets the switch-to-supplicant retransmission time for EAP-request
frames. The range is 1 to 65,535 seconds. The default value is 30
seconds.
Mode
Port Interface mode
Description
Use this command to set the retransmission time for EAP-request frames
from authenticator ports.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 951 or “SHOW DOT1X
INTERFACE” on page 956
Example
This example sets the retransmission time for EAP-request frames on
authenticator ports 1.0.3 and 1.0.4 to 120 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.3,port1.0.4
awplus(config-if)# auth timeout supp-timeout 120