Allied Telesis AT-9000/28SP User Manual

Chapter 64: SNMPv3 Commands
1002
NO SNMP-SERVER ENGINEID LOCAL
Syntax
no snmp-server engineid local
Parameters
None
Mode
Global Configuration mode
Description
Use this command to return the SNMP engine ID value to the default
value.
Confirmation Command
“SHOW SNMP-SERVER” on page 1008
Example
This example returns the SNMP engine ID value to the default value:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server engineid local

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)