Allied Telesis AT-9000/28SP - Figure 96: SHOW LOG CONFIG Command; Show Log Config; Table 54. SHOW LOG CONFIG Command

Chapter 33: Event Log Commands
524
SHOW LOG CONFIG
Syntax
show log config
Parameters
None
Modes
Privileged Exec mode
Description
Use this command to display the configuration of the event log.
awplus# show log config
Figure 96. SHOW LOG CONFIG Command
The fields in the display are described here:
Table 54. SHOW LOG CONFIG Command
Field Description
Level The severity levels of the messages to be
stored in the log. The default is level 6,
Informational, and higher. The levels are
defined in Table 51 on page 517.
Permanent log:
Status ................ Enable
Filter:
Level .............. Informational
Program ............ All
Message Text .......
Buffered log:
Status ................ Enable
Filter:
Level .............. Informational
Program ............ All
Message Text .......