Allied Telesis AT-9000/28SP User Manual

AT-9000 Switch Command Line User’s Guide
1099
LLDP TIMER
Syntax
lldp timer interval
Parameters
interval
Specifies the transmit interval. The range is 5 to 32768 seconds.
Mode
Global Configuration mode
Description
Use this command to set the transmit interval. This is the interval between
regular transmissions of LLDP advertisements. The transmit interval must
be at least four times the transmission delay timer, set with “LLDP TX-
DELAY” on page 1104.
Confirmation Command
“SHOW LLDP” on page 1121
Example
This example sets the transmit interval to 60 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# lldp timer 60

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)