Allied Telesis AT-9000/28SP - Page 815

AT-9000 Switch Command Line User’s Guide
815
Use the VLAN SET
MACADDRESS command in the
Port Interface mode to designate
port 1 as an egress port of all the
MAC addresses.
awplus(config-if)# vlan set 21 macaddress 00:30:84:54:1a:45
awplus(config-if)# vlan set 21 macaddress 00:30:84:c3:5a:11
awplus(config-if)# vlan set 21 macaddress 00:30:84:22:67:17
awplus(config-if)# vlan set 21 macaddress 00:30:84:78:75:1c
awplus(config-if)# vlan set 21 macaddress 00:30:79:7a:11:10
awplus(config-if)# vlan set 21 macaddress 00:30:42:53:10:3a
awplus(config-if)# end
Return to the Privileged Exec
mode.
awplus# show vlan macaddress
Confirm the configuration, again
with the SHOW VLAN
MACADDRESS command.
awplus# configure terminal
Enter the Global Configuration
mode.
awplus(config)# interface port1.0.2-port1.0.6
Enter the Port Interface mode for
ports 2 to 6.
awplus(config-if)# vlan set 21 macaddress
00:30:84:54:1a:45
Use the VLAN SET
MACADDRESS command in the
Port Interface mode to assign the
ports one MAC address.
awplus(config-if)# end
Return to the Privileged Exec
mode.
awplus# show vlan macaddress
Confirm the configuration with the
SHOW VLAN MACADDRESS
command.