EasyManuals Logo

Allied Telesis Rapier Series User Manual

Allied Telesis Rapier Series
65 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
46 Rapier Series Switch
C613-03020-00 REV K
Rapier 8/8MT
Rapier 48w
NSMs slot into a base-unit switch and either directly provide additional
interfaces, or provide multiple slots where additional interfaces can be added.
The following NSMs are available:
AT-AR040 (4 Port Interface Card (PIC) slots)
AT-AR041 (8 BRI S/T WAN Ports)
AT-AR042 (4 BRI S/T WAN Ports)
AT-AR048 (1 unchannelised DS3 port)
The AT-AR048 can be used only in the Rapier 48w and in Rapier 24i models
whose serial number ends in J or higher (N or higher for maximum
performance). A label with the serial number can be found on the underside of
the switch.
For more information on NSMs, contact your authorised Allied Telesis
distributor or reseller, or see the Network Service Module Hardware Reference.
This and other documentation can be found on the CD-ROM bundled with
your switch, or at www.alliedtelesis.com/support/software.
Port Interface Cards (PICs)
PICs provide a cost effective and flexible mechanism for adding new or
additional WAN network interfaces to the switch. By adding or changing PICs,
the switch’s network interface capabilities can be upgraded without replacing
the switch itself. A PIC can provide additional network interfaces, or can be
replaced with a different PIC to provide alternative interface types.
An AT-AR040 NSM must be installed before PICs can be used with Rapier
Switches.
The following PICs can be used in the AT-AR040 NSM when it is installed in a
Rapier switch (with a maximum of two E1/T1/PRI cards):
AT-AR020 PRI E1/T1
AT-AR021 (S) BRI S/T
AT-AR021 (U) BRI U
AT-AR023 SYN
AT-AR024 ASYN4
AT-AR027 VoIP-FXS
We recommend that AT-AR022 ETH PICs and AT-AR026 4ETH PICs not be
used in the NSM PIC bays because performance of these interfaces is likely to
be reduced and packet loss may occur.
For more information on PICs, contact your Authorised Allied Telesis
distributor or reseller, or see the Port Interface Card Hardware Reference. This and
other documentation can be found on the CD-ROM bundled with your switch,
or at www.alliedtelesis.com/support/software.

Other manuals for Allied Telesis Rapier Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis Rapier Series and is the answer not in the manual?

Allied Telesis Rapier Series Specifications

General IconGeneral
BrandAllied Telesis
ModelRapier Series
CategorySwitch
LanguageEnglish

Related product manuals