2.0 Installation, continued
2.5 Programming the PIM, continued
2.5.1 The Setup Menu
cannot be edited.
ADDRESS. Manually reset these options.
NOTE:
Press the Enter key to access the Setup Menu.
individually select sub-menu items.
To select and change a value in the Setup Menu:
Press either UP or DOWN to put the display in the Manual Scroll Mode.1.
Continue pressing UP or DOWN until the desired item is displayed.2.
Press ENTER to select the item to edit. 3.
Press UP to increase the displayed value, or DOWN to decrease the value. 4.
To change the displayed values more rapidly, in Edit mode, press either UP or
5.
If an incorrect value is accidently entered, repeat the above process and enter
the proper value, or select the SET DEFAULTS menu selection of the Setup
values.
To return to the Operation Normal menu, press ESCAPE three times.6.
28
017-877-B1-001 Rev. A
To Next Page
Loading...
