4.0 Operation, continued
4.4 Alarm Indications, continued
Table 4-2, Major Alarms
Note 1: To clear a Latched Self-Test Fail Alarm, initiate and complete a successful self-test.
Note 2: Remove and replace XM2-300HP. Do not try to clear alarm or while in service.
NOTE:
Major Alarms
Active Alarm Probable Cause of Alarm Corrective Action
SELF TEST STATUS
during Selt Test.
Predicted overall health of the inverter calculated by the
The output is overloaded or shorted.
2. REDUCE OUTPUT LOAD
OUTPUT 1 TRIPPED
is overloaded.
1. REDUCE OUTPUT LOAD
CHARGER FAILURE
temperature.
2. PERFORM SELF TEST
CONFIG ERROR
-
tion is suspended until error is corrected.
Predicted overall health of the batteries calculated by
2. REPLACE BATTERIES
LOW BATT WARNING
1. SHUTDOWN IMMINENT
3. CONNECT GENERATOR
HIGH BATT WARNING
LOW
Conductance delta major alarm threshold has been
OUTPUT FAIL
LINE ISOLATION
AC plug is connected to the inverter. The potential for
45
017-877-B1-001 Rev. A
To Next Page
Loading...
