4. 0 Operation, continued
4.6 Smart Display Glossary, continued
Overcurrent Tolerance Period: An output overcurrent condition is tolerated on either of
is installed.
Power Supply priority:
the priority level of the unit at time of service if multiple service calls are issued simultaneously.
Reset Output 1, Reset Output 2: Programming this feature resets the corresponding output
in the event one or both outputs are tripped. Upon clearing the alarm, either manually or via
Retry Delay:
each attempt to restart an output connection. A value greater than 600 seconds disables the
Retry Limit: PIM fault retry count limit. This is the number of times the XM2-300HP attempts
Set Defaults:
Self Test:
test 30 seconds after initial start up
Standby Events: XM2-300HP standby events counter. This does not include self test events.
Standby Time: The total amount of time the XM2-300HP has operated in standby mode. This
does not include self test time and represents the sum total number of minutes of AC line failure
Technician ID number: The Technician ID number is determined by the service provider and is
entered to record the service history of the unit.
Test Countdown:
Test Duration: Automatic self test duration timer. This sets the number of minutes the XM2-
300HP performs a battery maintenance cycle test. This timer applies to automatically or
manually initiated tests.
Test Discharge percentage:
Test Inhibit:
Test Interval:
Total Run Time:
operation. This is not a resetable value.
Resetting factory defaults does not clear Standby Events or Standby Time.
NOTE:
49
017-877-B1-001 Rev. A
To Next Page
Loading...
