MTX-30F Push Installation & Operation Guide Page 12
From the Welcome screen either place your finger on the sensor OR enter your assigned
User ID using the keypad.
Follow the on screen prompt to remove finger OR input your password.
Upon verification, the screen will display your Name, User ID, and the confirmation "Verified“,
with the voice prompt "Thank you" followed by the momentary display of your hours worked
for the active pay period.
Note: The advantage of being enrolled as a user with a fingerprint template and password is that you
can use either method to punch. This provides an automatic backup should you encounter any
problems with fingerprint validation. Therefore, the first method used and accepted is the only method
you need to validate a punch.
Punching with a Fingerprint (FP) or Password (Pwd)
Punching with a Fingerprint (FP) and Password (Pwd)
From the Welcome screen either place your finger on the sensor OR enter your assigned User
ID using the keypad.
Follow the on screen prompt to Please Input Password and OK then Please Press Finger
(if User ID and Password was used).
Upon verification, the screen will display your Name, User ID, and the confirmation "Verified"
with the voice prompt "Thank you" followed by the momentary display of your hours worked for
the active pay period.
If View Hours is enable: The display will momentarily show the "As of" date followed by the
current pay period hours worked for the user that just punched in.
Note: When Recheck Min is set, if an employee punches more than once within the time setting
[usually 1 – 2 mins.], the voice prompt will be "Punch accepted…thank you" and no pay period
hours will be displayed.
View Previous Punch at the Terminal – F3
Press the F3 key to view Previous Punch. The terminal will ask for Badge No. or Fingerprint.
Select Date and press Ok to display previous punches.
Note: Previous punches are reset (cleared) every time the clock is polled.
To Next Page
Loading...
