MTX-30F Push Installation & Operation Guide Page 6
Wall Mounting
Warning! Before selecting a mounting location for your MTX-30F Push Terminal, you
must consider the following:
The mounting surface and hardware must be able to support the unit’s weight, 1.35
lbs. (0.61kg).
The area must be within the specified operating temperature & humidity range (see
Specifications on page 27).
The MTX-30F Push Fingerprint terminal should be mounted in an environment
that avoids the following conditions:
X Heat Source – Direct Sunlight and Humidity
X Rain Water
X Strong Vibration and Shock
X Dust, Corrosive Gas, Steam and Salt Damage
Close proximity to a wall outlet (6 ft.)
If using Ethernet, close proximity to an Ethernet connection (6 ft.) or if connecting via
WiFi check the location for a good signal.
Amano recommends the following wall mounting procedure:
1. Set the MTX-30F Push terminal face up on a flat surface to avoid scratches on display.
2. Using the mounting bracket as a guide, mark the location of the upper and lower
mounting holes on the wall. It is recommended to mount the terminal 49.2” from the
floor to the bottom of the bracket. *Adjust for staff height as necessary.
Note: Pay attention to the orientation. The back plate should only be mounted one-way as it is
keyed to fit into the back of the fingerprint reader.
Mounting Bracket
Basic Installation for Time Guardian MTX-30F Push
Back of Terminal
TOP
BOTTOM
To Next Page
Loading...
