Commissioning
26 Amatron+ BAG0082.2 10.10
5.5 Calibration test
The calibration test checks whether the sowing rate is correct during
later sowing.
The calibration test must always be carried out
when the seed type is changed
if the seed type is identical, but size grain, grain shape, specific
weight and dressing are different
when the dosing roller is changed
if there are any differences between the calibration test and
actual sowing rates.
Select "Calibrate seed drill" in main menu!
With divided hopper:
Calibrate Tank 1 and Tank 2
separately.
1. Prepare calibration test in accordance with
the seed drill operating manual!
2.
Call up seed type submenu.
Select seed type.
Enter the 1000 grain weight.
Quantity display in kg / ha or grains /
m
2
.
3.
Test/enter desired sowing rate.
This value can also be entered in the
job menu. (see on page 24).
4. Enter planned subsequent working
speed (km/h).
5.
Set the calibration factor before the
first calibration to 1.00 or an experience
value.
6. Check whether the correct dosing roller is
fitted (coarse, medium, fine).
7.
Fill the cells of the dosing roller with
the predosing. The running time is adjust-
able (see on page 43).
Fig. 30
To Next Page
Loading...
