Amazone Cenius 3003 - Page 54

Commissioning
6.1.1.7 Table
Actual value according to
calculation
Approved value ac-
cording to tractor
instruction manual
Double approved
load capacity (two
tyres)
Minimum ballast
front/rear
/ kg -- --
Total weight kg
≤
kg --
Front axle load kg
≤
kg
≤
kg
Rear axle load kg
≤
kg
≤
kg
• You can find the approved values for the total tractor weight,
axle loads and load capacities in the tractor registration papers.
• The actually calculated values must be less than or equal to
(≤ ) the permissible values!
WARNING
Crush, cut, entanglement, pulling in and impact hazards caused
by poor stability and insufficient steering and braking capacity
of the tractor.
It is forbidden to couple the machine to the tractor used as the basis
for calculation, if
• One of the actual, calculated values is greater than the approved
value.
• There is no front weight (if required) attached to the tractor for
the minimum front ballast (G
V min
).
You must use a front weight, which is equal to at least the required
minimum front ballast (G
V min
).
54
Cenius 03 BAG0144.5 10.19