Amazone Cirrus 03 - Exchanging the Exact Following Harrow and the Roller Harrow with each Other

Cleaning, maintenance and repairs
Cirrus 03 BAH0101-05 11.19
331
Specialist workshop work
Replace the plastic parts:
Replace the plastic parts if worn (Fig. 497/1).
Do
not unscrew the holder (Fig. 497/2) from the frame
(Fig. 497/3)
.
Fig. 497
12.7.17 Exchanging the exact following harrow and the roller harrow with each other
12.7.17.1 Preparing the roller harrow
Specialist workshop work:
1. Screw the bottom part of the spindle (Fig.
498/1) onto the roller harrow:
Tightening torque: 49 Nm.
Fig. 498
Install the bottom part of the spindle such that,
during subsequent mounting of the roller harrow,
 the press rollers (Fig. 499/1) are aligned
with the coulters (Fig. 499/2).
 the bottom part of the spindle is aligned with
the top part of the spindle on the implement.
Fig. 499