Amazone FTender 1600 - Coupling the implement; Driving the tractor towards the implement; Coupling the power supply; Connecting the conveyor line

6.2 Coupling the implement
6.2.1 Driving the tractor towards the implement
Enough space must remain between the tractor and
implement so that the supply lines can be coupled
without obstructions.
Drive the tractor towards the implement, leaving a
sufficient distance.
CMS-I-00004045
6.2.2 Coupling the power supply
1. Insert the plug
1
for the power supply.
2. Route the power supply cable with sufficient
freedom of movement and without chafing or
pinching points.
3. Check the lighting on the implement for proper
function.
1
CMS-I-00001048
6.2.3
Connecting the conveyor line
Depending on the implement equipment, there are
one or two conveyor lines.
NOTE
Pay attention to the marking
A
and
B
.
1. Connect the connector
1
to the conveyor line
3
.
2. Connect the clamp
2
.
CMS-I-00002609
CMS-T-00003200-I.1
CMS-T-00005794-D.1
CMS-T-00001399-G.1
CMS-T-00003560-E.1
6 | Preparing the machine
Coupling the implement
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
47