Amazone FTender 1600 - Adjusting the Low Level Sensor

4. Disconnect the 6-pin plug
2
from the interface
on the FTender
1
.
5. Take the connection cable from the holder
3
.
3
2
1
CMS-I-00003743
6. Route the connection cable
2
with the 6-pin
plug
1
to the interface of the hose package.
7. Connect the 6-pin plug to the interface of the
hose package.
1
2
CMS-I-00003744
6.3.12 Adjusting the low level sensor
1. If low spread rates should be metered:
Insert the low level sensor in the lower mount
2
or
If high spread rates should be metered:
Insert the low level sensor in the upper mount
1
.
NOTE
As soon as the low level sensor is no longer
covered, a warning message appears on the
control terminal.
When the low level sensor is inserted in the lower
mount, the warning message appears very late.
12
CMS-I-00003675
CMS-T-00003330-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
74