Amazone FTender 1600 - Mounting the T-Pack F

6.3.14 Mounting the T-Pack F
Before the T-Pack F can be connected to the
FTender:
The T-Pack F transport lock must be removed
Removing the lower link mountings
Removing the working position sensor from the
FTender
Mounting the T-Pack F on the FTender
Installing the working position sensor on the T-
Pack F
Installing the transport lock on the FTender
1. To dismount the T-Pack F transport lock:
Remove the nuts and washers
2
.
2. Remove the bolts
3
.
3. Remove the operating handle
1
.
1
2
3
CMS-I-00003642
4. Remove the linch pin
3
5. Remove the nuts and washers
4
.
6. Remove the locking plate
2
.
7. Remove the bolts
4
.
1
2
3
4
CMS-I-00003641
CMS-T-00003331-D.1
6 | Preparing the machine
Preparing the implement for operation
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
76