Amazone FTender 1600 - Installing ballast weights

12. Empty the calibration bucket.
13. Put the calibration bucket in the storage
compartment.
14. Close the calibration flap
2
.
15. Lock the locking lever
1
on the metering
housing.
1
2
CMS-I-00003654
16. To activate both conveyor sections
2
,
put the lever
1
back in the centre position.
17. If the implement is equipped with a 2-chamber
hopper,
calibrate the second metering unit.
R
L
1
2
CMS-I-00002543
6.3.8
Operating the one-sided switching
For certain working widths for crop maintenance, it
is necessary to perform the first field pass with the
seed drill with half the working width. For example,
when beginning field work at the left field edge, the
coulters on the right side of the implement do not
deposit seeds in the soil.
1. To deactivate the conveyor section
3
,
unlock the control lever
1
.
2. Put the control lever in the indicated position.
The conveyor section
2
is activated.
R
3
2
1
CMS-I-00003649
CMS-T-00003562-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
69