To actuate the working position sensor:
actuate the "yellow 1" tractor control unit
or
To switch the working position sensor via
headland management:
refer to the "tractor" operating manual.
7.3 Turning on the headlands
NOTE
Depending on the implement equipment, the
spreading material comes out of the coulters
until the conveyor section is empty.
If the seed drill is lifted at the end of the field,
the metering unit on the front-mounted hopper
is switched off automatically.
1. To prevent accumulations of metered material
in the conveyor hose:
prioritise the "red" tractor control unit.
2. To prevent lateral loads when driving in curves:
Lift the implement.
3. When the direction of the implement matches
that of the direction of travel:
lower the implement.
CMS-T-00003117-D.1
7 | Using the machine
Turning on the headlands
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
89
To Next Page