Amazone FTender 1600 - 8 Eliminating Faults

Eliminating faults
8
Errors Cause Solution
The control terminal displays a fan
speed that is too high.
The hydraulic control unit is
incorrectly adjusted.
To adjust the fan speed,
see "Setting the fan speed".
The control terminal displays a
metering shaft speed that is too
low.
The metering roller is rotating stiffly. To check the metering unit,
see "Calibrating the spread
rate".
The metering roller is blocked by
foreign objects in the metering
housing.
To clean the metering unit,
see "Cleaning the metering
unit".
The electric drives do not run or
start running at the wrong time.
The switch points of the working
position sensor are wrong.
To  the working
position sensor,
see "Configuring the working
position sensor".
Pressure cannot be produced in
the conveyor system.
The seal for the pressure lid is not
properly seated.
Adjust the stop bolts on the
pressure lid.
CMS-T-00003128-B.1
8 | Eliminating faults
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
90