Amazone FTender 1600 - Page 83

8. To dismount the lower link receptacles:
Remove the lower link pin
2
.
9. Loosen all bolted connections
3
and remove
them.
10. Remove the lower link mountings.
11. Remove the clamps
1
.
1
2
4
3
CMS-I-00002519
12. To dismount the working position sensor from
the FTender:
Remove the nuts and washers
2
.
13. Remove the working position sensor
1
.
1
2
CMS-I-00003636
14. To couple the T-Pack F onto the tractor:
See "Coupling the 3-point mounting frame".
15. To move the parking supports into the upper
position:
See section "Using the parking supports".
16. Slowly drive the tractor forwards.
Position the T-Pack F in the tractor lift linkage
1
centrally on the FTender
2
.
1
2
CMS-I-00002517
6 | Preparing the machine
Preparing the implement for operation
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
77