Amazone FTender 1600 - Turning on the headlands

21. Tighten the nuts
1
.
22. Tighten the nuts
2
.
2
1
174 Nm
174 Nm
CMS-I-00003645
23. To mount the working position sensor on the
FTender:
Install the working position sensor
1
on the
desired top link mounting
3
or
4
.
24. Install the nuts and washers
2
and tighten them.
25. To adjust the working position sensor to the top
link:
See section "Adjusting the working position
sensor".
1
4
3
2
CMS-I-00003637
26. To mount the T-Pack F transport lock:
Install the locking plate
2
.
27. Install the bolts
4
.
28. Install the washers and nuts
4
and tighten them.
29. Install the linch pin
3
.
1
2
3
4
CMS-I-00003641
6 | Preparing the machine
Preparing the implement for operation
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
83