pressure and the spray pressure prescribed in the spray ta-
ble.
• Before starting spraying, determine the exact application rate
required, referring to the instructions of the crop protection agent
manufacturer.
→ Before you start spraying, enter the required application rate
(target rate) on control terminal.
• During spraying operation, precisely adhere to the required ap-
plication rate [l/ha]
ο in order to achieve the best possible results from your crop
protection measure.
ο to avoid unnecessary pollution of the environment.
• Select the required nozzle type from the spray table before
spraying starts, taking account of
ο the intended forward speed,
ο the required application rate and
ο the required atomisation characteristic (fine, medium or
coarse-dropped) of the crop protection agent used for the
crop protection measure.
Refer to the section "Spray tables for flat-fan, anti-drift, in-
jector and airmix nozzles", Seite 238.
• Select the required nozzle size from the spray table before
spraying starts, taking account of
ο the intended forward speed,
ο the required application rate and
ο the target spray pressure.
Refer to the section "Spray tables for flat-fan, anti-drift, in-
jector and airmix nozzles", Seite 238.
• Select a low forward speed and a low spray pressure to prevent
drift losses!
Refer to the section "Spray tables for flat-fan, anti-drift, injector
and airmix nozzles", Seite 238.
• At wind speeds of 3 m/s, take ad
To Next Page
Loading...
Need help?
General
