UX01 Super CP Plus BAG0157.3 03.18
Driving to the field with the agitator switched on
2. Switch on the PTO shaft.
3. Control terminal: Select the desired intensi-
ty for the agitator.
11.3.2 Drift reduction mesures
• Reschedule treatment for the early morning or the evening hours
(there is generally less wind).
• Choose larger nozzles and a higher water application rate.
• Reduce the spray pressure.
• Precisely maintain the working height of the boom, because the
risk of drifting rises very sharply as the distance between the
nozzles increases.
• Reduce forward speed (to less than 8 km/h).
• Use so-called anti-drift (AD) nozzles or injector (ID) nozzles
(nozzles which produce a high proportion of coarse drops).
• Observe the distance requirements of the respective crop pro-
tection agent
11.3.3 Diluting the spray liquid with flushing water
Control terminal, Cleaning menu:
2.
Dilute the spray liquid with flushing
water.
3.
End dilution.
Observe the display for the required quantity of
flushing water.
The spray agent can be diluted for 2 reasons:
• To get rid of excess residual quantities.
Excess residual quantities in the spray liquid tank are initially
diluted with 10 times the quantity of flushing water to then spray
them out on the field that has already been treated.
• Increasing the spray liquid volume to treat a remaining area.
The spray line is flushed on machines with nozzle control. When re-
starting the spraying, two to five minutes will elapse until concentrated
spray liquid can be applied.
To Next Page
Loading...
Need help?
General
